v6.0 – Supported features – Thank you paciotti! – Improved design with noise protection from high voltage spikes – Snaps on RaspberryPi Zero/3/2 – Supports both 3.3V and 5V BME sensors. – Dual relay can control 2 independent contacts, like heating thermostat, AC, fan or hot water – Relays offer both N.C. and N.O....

Supported features Snaps on RaspberryPi Zero/3/2 Supports all DHT11/22/AM2302/BME280 sensors (use appropriate pins and 4.kΩ in R3 if needed). Supports both 3.3V and 5V sensors. Dual relay can control 2 independent contacts, like heating thermostat and hot water Relays offer both N.C. and N.O. contacts to choose (N.O. contacts used by default) Humidity unpopulated...

Supported features Snaps on RaspberryPi Zero Supports DHT11/22/AM2302 sensor Dual relay can control 2 independant contacts Humidity unpopulated contact labelled ‘Hum’ provide LOW/HIGH signal 3.3V Known issues Pinout mistake – Do not use Note that last 4 GPIO contacts are note used (GPIO26, GPIO20, GND, GPIO21)